Galvin Specialised Ezy-Drink CP-BS TD15EB 제품 설치 매뉴얼 - 페이지 4

{카테고리_이름} Galvin Specialised Ezy-Drink CP-BS TD15EB에 대한 제품 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galvin Specialised Ezy-Drink CP-BS TD15EB 4 페이지. Remote electronic drinking bubbler tap - battery

페이지 인쇄

SET WATER FLOW DURATION

Button

− Switch the power to the controller off.

After 5 seconds switch the power on.

− Locate the light on the controller.

− Press the piezo button 4 times.

− The green light on the controller

should flash 5 times.

TROUBLESHOOTING

PROBLEM

Water is not flowing from

tap

Rate of flow inadequate

WARRANTY

The warranty set forth herein is given expressly and is the only warranty given by the Galvin Engineering Pty

Ltd. With respect to the product, Galvin Engineering Pty Ltd makes no other warranties, express or implied.

Galvin Engineering Pty. Ltd. hereby specifically disclaims all other warranties, express or implied, including but

not limited to the implied warranties of merchantability and fitness for a particular purpose.

Galvin Engineering Pty Ltd products are covered under our manufacturer's warranty available for download from

www.galvinengineering.com.au Galvin Engineering Pty Ltd expressly warrants that the product is free from

operational defects in workmanship and materials for the warranty period as shown on the schedule in the

manufacturer's warranty. During the warranty period, Galvin Engineering will replace or repair any defective

products manufactured by Galvin Engineering without charge, so long as the terms of the Manufacturer's

warranty are complied with.

The remedy described in the first paragraph of this warranty shall constitute the sole and exclusive remedy for

breach of warranty, and Galvin Engineering Pty Ltd shall not be responsible for any incidental, special or

consequential damages, including without limitation, lost profits or the cost of repairing or replacing other

property which is damaged if this product does not work properly, other costs resulting from labour charges,

delays, vandalism, negligence, fouling caused by foreign material, damage from adverse water conditions,

chemical, electrical or any other circumstances over which Galvin Engineering has no control. This warranty

shall be invalidated by any abuse, misuse, misapplication, improper installation or improper maintenance or

alteration of the product.

Controller

− Once again, push the piezo button 5 times.

− The red light on the controller should now be lit.

− Leave the red light on for the desired flow

duration time.

− Press the button to finish setting the time.

CAUSE

Water is turned off

Blocked flow restrictor

The flow regulator screw may

not be adjusted correctly

Version 1, 16

June, Page 4 of 4

RECTIFICATION

Turn on water

Remove restrictor and clean

Remove blanking screw and adjust flow

regulating screw as described above