AgTerra SprayLogger E3 설치 및 빠른 시작 매뉴얼 - 페이지 8

{카테고리_이름} AgTerra SprayLogger E3에 대한 설치 및 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AgTerra SprayLogger E3 16 페이지.

o If the SprayLogger unit is kept in a vehicle or container, check to verify that

the Bluetooth range is sufficient to stay connected to your device, and that

the GPS coordinates are accurate.

 Connect your flow sensor to your SprayLogger E3 box using the 6-pin yellow

cable. The female end (green) connects to the flow sensor; the 6-pin male end

connects to a flow port on the SprayLogger. The cables may be clipped for

optimum length. If your cabling is too short, longer cables are available from

AgTerra.

Note, the cables for the flow sensors and switches look alike, as do their

ports on the SprayLogger box. Unless you have a custom configuration, flow

ports are labeled A, B and C on the box and the switch ports are labeled 1 –

15. Flow sensor cables (6-pin) will fit flow sensor ports, and only switch port

cables (3-pin) will fit switch ports. Contact AgTerra if you need additional

Switches Installation

1) If your SprayLogger E3 includes optional switch channels, use the 3-C yellow

cable(s) included in your shipment.

See the wiring diagram on the next page for additional information.

cables or extensions.