HIKOKI WR 14VE 취급 지침 매뉴얼 - 페이지 17
{카테고리_이름} HIKOKI WR 14VE에 대한 취급 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKOKI WR 14VE 20 페이지.
페이지 인쇄
MAINTENANCE AND INSPECTION
1.
Inspecting the socket
A worn or deformed hex or a square-holed socket will not give an adequate tightness to
the fi tting between the nut or anvil, consequently resulting in loss of tightening torque. Pay
attention to wear of socket holes periodically, and replace with a new one if needed.
2.
Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that they are properly tightened. Should
any of the screws be loose, retighten them immediately. Failure to do so could result in
serious hazard.
3.
Maintenance of the motor
The motor unit winding is the very "heart" of the power tool.
Exercise due care to ensure the winding does not become damaged and/or wet with oil or
water.
4.
Replacing supply cord
If the replacement of the supply cord is necessary, this has to be done by the manufacturer
of this agent in order to avoid a safety hazard.
CAUTION
In the operation and maintenance of power tools, the safety regulations and
standards prescribed in each country must be observed.
17
English