HIKOKI WR 14VE 취급 지침 매뉴얼 - 페이지 16

{카테고리_이름} HIKOKI WR 14VE에 대한 취급 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKOKI WR 14VE 20 페이지.

페이지 인쇄

English

The protection function

To protect the tool, the protection function will be activated, automatically shutting down the

unit in the event of any problems. (Table 1)

Mode indicator lamp

(see Fig. 6 on page 15)

Fast repeated ﬂ ashes

Flashes on and oﬀ with 0.1-second

Flashing

intervals

Slow repeated ﬂ ashes

Flashes on and oﬀ with 1-second

intervals

Flashing during mode operation

Excessive load protection function

For excessive load conditions, the tool will shutdown to prevent damage.

Discontinue the heavy load task and press mode switch to reset the tool.

Control monitoring function

Press mode switch to reset the tool.

Continual occurrences of this situation may be the result of damage to the tool.

Increased temperature protection function

Automatic shutdown is activated to prevent damage from high temperatures.

The tool's internal temperature will increase for tasks involving the use of large currents of

electricity, or when used in high temperature environments.

Please allow the tool to rest for 10 to 15 minutes before continuing a task.

Continuous operation prevention function

Shutdown will occur in the event of continuous operation while the switch remains ON.

Using the hook

(1)

Removing the hook.

Remove the screws ﬁ xing the hook with Philips

screw driver. (Fig. 7)

(2)

Replacing the hook and tightening the screws.

Install securely the hook in the groove of power tool

and tighten the screws to ﬁ x the hook ﬁ rmly.

Table 1

Automatic shutdown initiated by excessive

load (*1)

Automatic shutdown initiated due to

sensor detection trouble (*2)

Automatic shutdown initiated due to the

tool's internal temperature exceeding the

speciﬁ ed temperature level (*3)

Automatic shutdown initiated due to

approximately 5 minutes of continuous

no-load operation (*4)

Cause of shutdown

Hook

Fig. 7

Screw