Gree GWHD(36)ND3AO 설치 매뉴얼 - 페이지 11

{카테고리_이름} Gree GWHD(36)ND3AO에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gree GWHD(36)ND3AO 16 페이지. Multi ductless inverter

INSTALLATION OF POWER AND WIRING

Step 8

Indoor Unit Interconnecting Wire Connections

W RNING

Disconnect all electrical power to unit including disconnects,

fuses and circuit breakers.

1. Open front cover of indoor unit and remove field wiring terminal block cover.

2. Pull interconnecting wires up from back of indoor unit and position in close to the

terminal block on indoor unit.

NOTE: The indoor unit is powered from the outdoor unit, depending on local code,

a disconnect switch may need to be installed to a power supply circuit.

3. Connect wiring to indoor unit per connection diagram.

NOTE: Record wire colors and terminal references for uses with Outdoor Unit

wire connections.

4. Replace field wiring cover and close front cover of indoor unit.

INSTALLATION OF POWER AND WIRING

Step 9

Outdoor Unit Wire Connections

W RNING

Disconnect all electrical power to unit including disconnects,

fuses and breakers.

1. Remove the service panel on right side of the outdoor unit.

2. Insert interconnecting wires and main power wires

through the wire holes on conduit mounting bracket.

3. Secure main power conduit (and interconnecting

wire conduit, if required) with locking nuts to

conduit mounting bracket

4. Open wire clamp/strain relief and adjust wire

lengths for proper connections to the outdoor unit

terminal block.

5. Following the same wire color and terminal references

from the indoor unit, tightly connect each interconnecting

wire to the terminal block per wiring diagram below.

NOTE: Crossing interconnecting wires will cause system malfunction and possible damage.

Multiple Port Conduit

Mounting Panel

(Reference Only)

Interconnecting

Wires

Main Power Wires

Multiple Port Cable

Connections

(Reference Only)