Gree GWHD(36)ND3AO 설치 매뉴얼 - 페이지 8

{카테고리_이름} Gree GWHD(36)ND3AO에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gree GWHD(36)ND3AO 16 페이지. Multi ductless inverter

페이지 인쇄

OUTDOOR UNIT PREPARATION

Step 5

Install Ground Pad or Wall Hangers

1. Determine proper location for outdoor unit.

2. Follow all instructions provided by manufacturer for installing wall hangers or ground pad.

3. Verify the wall hangers or ground pad can safely support the weight of the outdoor unit.

4. Verify the wall hangers or ground pad is level and meets all outdoor dimensional clearances.

Install Outdoor Unit Risers

If the outdoor unit requires added elevation above the ground, installing riser legs will provide

a sturdy and stable solution. Follow all instructions provided by manufacturer for installing

riser legs to outdoor unit.

NOTE: Riser legs will also help absorb vibrations and noise while facilitating proper drainage.

W RNING

Florida Wind Load Requirements state that outdoor unit must be anchored to

concrete pad using four 3/8-in diameter Power Wedge Bolt Plus (or equivalent)

with 1-in diameter fender washers. Anchor bolts must be embedded into

3,000 PSI minimum concrete at a distance of 4 1/2-in from any concrete edge.

The concrete thickness must exceed 1.5 times the anchor depth.

Install Condensate Drain for Outdoor Unit

During normal heating and defrost operation,

the outdoor unit will generate condensate water.

The condensate water should be routed to a safe

location through the drain hose.

1. Locate drain hole on bottom of outdoor unit.

2. Install the outdoor drain fitting into hole on

the bottom of outdoor unit as shown.

3. Connect the drain hose to drain fitting.

4. Route drain hose to safe location for proper

drainage of excess condensate water.

Drain Fitting Installation

INSTALLATION OF REFRIGERANT PIPING

Step 6

Piping Connections

C UTION

Use refrigeration grade tubing ONLY. No other type of tubing may be used. Use

of other types of tubing will void manufacturer's warranty. Make sure there is

enough piping to cover the required length between the outdoor and indoor unit.

Piping Preparation

• Do not open service valves or remove protective caps from tubing ends until all

connections are made.

• Keep tubing free of dirt, sand, moisture and contaminants.

• Use a flexible condensate drain hose to fit over the factory 5/8-inch (16mm) drainage hose.

• Insulate each refrigerant pipe and condensate hose with minimum 3/8" (10 mm) wall

thermal pipe insulation.

NOTE: Insulate condensate hose to prevent sweating which may cause water stains

or wall damage.

• Bind refrigerant pipes, condensate hose and interconnecting wire together with cable

ties at 12 inch intervals.

NOTE: A condensate pump accessory (sold separately) is recommended for the

indoor unit when adequate line pitch cannot be provided for drainage.