Maiwe MIEN2205 사용자 설명서 - 페이지 2
{카테고리_이름} Maiwe MIEN2205에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Maiwe MIEN2205 6 페이지. Industrial ethernet switch
Maiwe MIEN2205에 대해서도 마찬가지입니다: 사용자 설명서 (18 페이지), 사용자 설명서 (14 페이지), 사용자 설명서 (5 페이지)
페이지 인쇄
3
Interface description
Ground screw
DIN-RAIL kit
Item
Description
Crimp one end of the grounding screw with the cold-pressed
terminal. The other end of the grounding wire is connected
Ground screw
to the ground, and the grounding wire is not less than
2.5mm2
Power interface
Support Dual DC12-48V
Supports automatic MDI/MDI-X connection. You can connect the
Ethernet RJ45
switch to terminal devices, servers, hubs, or other switches.
port
Din-rail kit
To fix the switch.
The indicator description of the switch is shown in the following table.
Indicator lights
Status
System Status LED
On
The power is connected and operating normally
PWR1/PWR2
The power is not connected or the system is not operating
Off
normally
The system is operating normally (some models are always
Flashing
RUN
on to indicate normally)
Off
The system is not working properly
Fiber Port Status LED
On
The port has established a valid network connection
LINK
Flashing
There is network activity on the port
Off
No valid network connection is established on the port
RJ45 Port Status LED
Each RJ45 port has two indicator lights, the yellow light is the port plastic rate indicator, the
green light is the port connection status indicator.
On
100M working state (namely 100Base-TX)
10/100M
(Yellow)
Off
10M working status (namely 10Base-T)
On
The port has established a valid network connection
Link/Act
Flashing
There is network activity on the port
(Green)
Off
No valid network connection is established on the port
Definition