Maiwe MIEN2205 사용자 설명서 - 페이지 3
{카테고리_이름} Maiwe MIEN2205에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Maiwe MIEN2205 6 페이지. Industrial ethernet switch
Maiwe MIEN2205에 대해서도 마찬가지입니다: 사용자 설명서 (18 페이지), 사용자 설명서 (14 페이지), 사용자 설명서 (5 페이지)
페이지 인쇄
Hardware installation
4
Installation and safety Precautions
To prevent equipment damage or personal injury caused by improper use, observe
the following precautions:
During the installation process, you need to wear anti-static gloves or anti-static
gloves, and power-off the switch.
Please make sure that the input voltage is within the input voltage range marked
on the switch.
The transmission distance has a certain relationship with the connected wire. It
is recommended to use a standard Cat5e/6 network cable.
The equipment must be grounded for lightning protection, otherwise the
protection level of the equipment will be greatly reduced; please use a wire of No.
20 or more to connect the grounding terminal to the ground.
The power line, ground line and signal line are laid out separately and the
distance is not less than 5cm.
Please pay attention to the symbol below for marking label.
Device installation
Tilt the switch upwards so that the upper end of the buckle is fastened to the
upper end of the DIN rail.
Network cables connection
Connect the optical fiber and network cable to the port in the correct
Catagory5 direct connection
Optical fiber connection
Connect the optical fiber to the corresponding optical fiber interface. The optical
fiber interface is used in pairs (TX and RX as a pair), TX is optical receiver, RX is
optical sender.
Device connection
Catagory5 crossover connection