HIKVISION D0T 사용자 설명서 - 페이지 9
{카테고리_이름} HIKVISION D0T에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKVISION D0T 17 페이지. Audio turret camera
HIKVISION D0T에 대해서도 마찬가지입니다: 사용자 설명서 (17 페이지), 사용자 설명서 (15 페이지), 사용자 설명서 (11 페이지), 사용자 설명서 (11 페이지), 사용자 설명서 (17 페이지)
페이지 인쇄
For cement wall/ceiling, expansion bolts are
required to fix the camera. For wooden
wall/ceiling, self-tapping screws are required.
4. Route the cables through the cable hole, or the side
opening.
5. Install the camera back to the mounting base and
secure them with the trim ring.
6. Connect the corresponding power cord, and video
cable.
7. Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
not, adjust the camera according to the figure below
to get an optimum angle.
8. Tighten the trim ring by clockwise rotating it.
2.3 Installation of Type III/IV Camera
Before you start:
The installation of ceiling mounting and wall mounting
are similar. Following takes ceiling mounting as an
example.
1. Disassemble the camera by rotating the camera to
align the notch to one of the marks.
2. Pry the mounting base by using a flat object, e.g., a
coin.
Figure 2-8 Disassemble the Camera
3. Drill the screw holes and the cable hole (optional)
on the ceiling.
Note:
Drill the cable hole, when adopting the ceiling outlet
to route the cable.
4. Attach the mounting base to the ceiling, and secure
it with supplied screws. For cement ceiling, you
need to mount the expansion bolts at first.
Figure 2-9 Attach the Mounting Base to the Ceiling
Figure 2-6 Install the Camera back
Figure 2-7 3-Aixs Adjustment
Mark
Notch