HIKVISION D0T Gebruikershandleiding - Pagina 9

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} HIKVISION D0T. HIKVISION D0T 17 pagina's. Audio turret camera
Ook voor HIKVISION D0T: Gebruikershandleiding (17 pagina's), Gebruikershandleiding (15 pagina's), Gebruikershandleiding (11 pagina's), Gebruikershandleiding (11 pagina's), Gebruikershandleiding (17 pagina's)

For cement wall/ceiling, expansion bolts are



required to fix the camera. For wooden

wall/ceiling, self-tapping screws are required.

4. Route the cables through the cable hole, or the side

opening.

5. Install the camera back to the mounting base and

secure them with the trim ring.

6. Connect the corresponding power cord, and video

cable.

7. Power on the camera to check whether the image

on the monitor is gotten from the optimum angle. If

not, adjust the camera according to the figure below

to get an optimum angle.

8. Tighten the trim ring by clockwise rotating it.

2.3 Installation of Type III/IV Camera

Before you start:

The installation of ceiling mounting and wall mounting

are similar. Following takes ceiling mounting as an

example.

1. Disassemble the camera by rotating the camera to

align the notch to one of the marks.

2. Pry the mounting base by using a flat object, e.g., a

coin.

Figure 2-8 Disassemble the Camera

3. Drill the screw holes and the cable hole (optional)

on the ceiling.

Note:

Drill the cable hole, when adopting the ceiling outlet

to route the cable.

4. Attach the mounting base to the ceiling, and secure

it with supplied screws. For cement ceiling, you

need to mount the expansion bolts at first.

Figure 2-9 Attach the Mounting Base to the Ceiling

Figure 2-6 Install the Camera back

Figure 2-7 3-Aixs Adjustment

Mark

Notch