HIKVISION D0T 사용자 설명서 - 페이지 6
{카테고리_이름} HIKVISION D0T에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKVISION D0T 17 페이지. Audio turret camera
HIKVISION D0T에 대해서도 마찬가지입니다: 사용자 설명서 (17 페이지), 사용자 설명서 (17 페이지), 사용자 설명서 (15 페이지), 사용자 설명서 (11 페이지), 사용자 설명서 (11 페이지)
페이지 인쇄
2 Installation
Before you start
Make sure that the device in the package is in good
condition and all the assembly parts are included.
Make sure that all the related equipment is power-off
during the installation.
Check the specification of the products for the
installation environment.
Check whether the power supply is matched with
your power output to avoid the damage.
Make sure the wall is strong enough to withstand
three times the weight of the camera, and the
mount.
If the wall is cement, insert expansion bolts before
installing the camera. If the wall is wooden, use
self-tapping screws to secure the camera.
If the product does not function properly, contact
your dealer or the nearest service center. Do NOT
disassemble the camera for repair or maintenance by
yourself.
2.1 Installation of Type I Camera
2.1.1 Ceiling/Wall Mounting without Junction Box
Before you start:
The installation of ceiling mounting and wall mounting
are similar. Following takes ceiling mounting as an
example.
Steps:
1. Disassemble the camera by rotating the camera to
align the notch to one of the line, as shown in the
figure below.
2. Pry the mounting base by using a flat object, for
example, a coin.
3. Drill the screw holes and the cable hole (optional)
on the ceiling.
4. Attach the mounting base to the ceiling and secure
it with supplied screws. For cement ceiling, you
need to install the expansion bolts at first.
Figure 2-3 Attach the Mounting Base to the Ceiling
5. Route the cables through the cable hole, or the side
opening.
Figure 2-1 Dissemble the Camera
Figure 2-2 Pry the Mounting Base
Expansion Bolts
Screws