HIKVISION D0T PIR Series 사용자 설명서 - 페이지 9
{카테고리_이름} HIKVISION D0T PIR Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKVISION D0T PIR Series 16 페이지. Turbo hd bullet camera
HIKVISION D0T PIR Series에 대해서도 마찬가지입니다: 사용자 설명서 (17 페이지)
페이지 인쇄
6. Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
not, adjust the surveillance angle.
Rotation Position
[0° to 360°]
1)
Loosen the No.1 adjusting screw to adjust the pan
position [0° to 360°]. Tighten the No.1 adjusting
screw.
2)
Loosen the No.2 adjusting screw to adjust the
tilting position [0° to 180°]. Tighten the No. 2
adjusting screw.
3)
Loosen the No.3 adjusting screw to adjust the
rotation position [0° to 360°]. Tighten the No.3
adjusting screw.
Ceiling/Wall Mounting with Junction Box
2.2.2
Before you start:
You need to purchase a junction box separately.
Steps:
1. Paste the drill template on the ceiling/wall.
2. Drill screw holes and the cable hole (optional) in the
ceiling/wall according to the holes of the drill
template.
Note:
Drill the cable hole, when adopting ceiling outlet to
route the cable.
3. Take apart the junction box, and align the screw
holes of the bullet camera with those on the
Junction box's cover.
4. Fix the camera on the junction box's cover with
three supplied screws.
Figure 2-12 Install the Junction Box
5. Secure the junction box's body with supplied screws
on the ceiling/wall.
Figure 2-10 3-Axis Adjustment
Figure 2-11 Drill Template
Pan Position
[0° to 360°]
1
Tilt Position [0° to 180°]
2
3
Junction Box
Cover