Gamma 6004 소유자 매뉴얼 - 페이지 11

{카테고리_이름} Gamma 6004에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma 6004 19 페이지. 6 point mounting
Gamma 6004에 대해서도 마찬가지입니다: 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (20 페이지)

페이지 인쇄

STRINGING THE FRAME

Pulling Tension

Wrap the loose section of string once around

the roller and insert the string between the

diamoind dust coated string gripper plates.

Pull the string perpendicular to the gripper

plates while slowly rotating the tensioner

crank clockwise until the brake lever pops

out of the latching block. The string is now

tensioned and can be clamped in place with

the remaining fixed clamp.

Repeat the above steps until all main strings

are installed. Tie off ends of main strings as

per racquet manufacturers recommenda-

tions.

Clamping the First Main String

To begin stringing the main strings, thread

the two ends of the string through the two

center holes at the appropriate end of the

frame and continue through the opposite

center holes. Thread one end of the string

through the adjacent grommet hole and pull

excess by hand. Secure one of the strings

using a string clamp.

Pull the remaining end of the string with the

tensioner to the desired tension. Secure the

string with the remaining clamp.

Completing the String Job

Weave the cross strings over and under the

main strings being careful to alternate the

weave direction of each consecutive cross

string so as to be opposite of the previously

installed cross string.

Once the final cross string is tensioned and

clamped, tie off at the appropriate hole speci-

fied by the racquet manufacturer.