Gamma 6004 Manual do Proprietário - Página 11

Procurar online ou descarregar pdf Manual do Proprietário para Máquinas de encordoar Gamma 6004. Gamma 6004 19 páginas. 6 point mounting
Também para Gamma 6004: Manual do Proprietário (20 páginas), Manual do Proprietário (20 páginas), Manual do Proprietário (20 páginas)

Imprimir página

STRINGING THE FRAME

Pulling Tension

Wrap the loose section of string once around

the roller and insert the string between the

diamoind dust coated string gripper plates.

Pull the string perpendicular to the gripper

plates while slowly rotating the tensioner

crank clockwise until the brake lever pops

out of the latching block. The string is now

tensioned and can be clamped in place with

the remaining fixed clamp.

Repeat the above steps until all main strings

are installed. Tie off ends of main strings as

per racquet manufacturers recommenda-

tions.

Clamping the First Main String

To begin stringing the main strings, thread

the two ends of the string through the two

center holes at the appropriate end of the

frame and continue through the opposite

center holes. Thread one end of the string

through the adjacent grommet hole and pull

excess by hand. Secure one of the strings

using a string clamp.

Pull the remaining end of the string with the

tensioner to the desired tension. Secure the

string with the remaining clamp.

Completing the String Job

Weave the cross strings over and under the

main strings being careful to alternate the

weave direction of each consecutive cross

string so as to be opposite of the previously

installed cross string.

Once the final cross string is tensioned and

clamped, tie off at the appropriate hole speci-

fied by the racquet manufacturer.