Gamma 6004 소유자 매뉴얼 - 페이지 8

{카테고리_이름} Gamma 6004에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma 6004 19 페이지. 6 point mounting
Gamma 6004에 대해서도 마찬가지입니다: 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (20 페이지)

페이지 인쇄

ASSEMBLY INSTRUCTIONS

Travel Stop

MOUNTING THE FRAME

Note: The tensioner bar is equipped with a

tensioner travel stop to limit travel of the

tensioner along the bar and prevent contact

between the tensioner and the racquet mount-

ing system while stringing. The travel stop is

located about midpoint along the tensioner

bar below the gear track.

To disengage the stop, pull and hold the

knob, rotate 90 degrees and release. To

engage the stop, repeat the above proce-

dure until the travel stop pin protrudes be-

yond the opposite surface of the tensioner

bar.

Setting the Gripper Jaw Spacing

The gripper jaws of the 6004 tensioner are

adjustable to accomodate varying string

gauges.

If the string slips through the gripper jaws

while pulling tension, rotate the gripper jaw

adjustment screw counter-clockwise.

If the string is damaged while pulling tension,

rotate the gripper jaw adjustment screw clock-

wise.

The jaws will be properly adjusted when

there is enough pressure to securely grip the

string without causing damage to the string.

Frame Support Post Adjustment

Place the racquet frame over the center

support slide. Screw the the post outward

until the center support of the racquet sup-

port slide is positioned on the inside surface

of the racquet frame.