Gamma 6004 소유자 매뉴얼 - 페이지 7

{카테고리_이름} Gamma 6004에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma 6004 19 페이지. 6 point mounting
Gamma 6004에 대해서도 마찬가지입니다: 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (20 페이지)

페이지 인쇄

ASSEMBLY INSTRUCTIONS

Clamp Head Installation

The post of the string clamp head and the tube of the

string clamp base are treated with grease to provide

protection against corrosion during shipping. Remove

any excessive grease with a clean cloth prior to use.

The post and tube may also be cleaned with isopropyl

alcohol. After this type of thorough cleaning, the post

and tube should be treated with a light coating of

machine oil to protect the surfaces against corrosion

and to ensure smooth operation.

Tensioner Installation

Remove the button head screw and washer

located at the end of the tensioner bar with

the 3 mm hex wrench provided. Slide the

tensioner onto the bar, being careful to align

the bar with all of the bearings and the drive

gear with the gear track. Replace the button

head screw and washer in the end of the

tensioner bar.

Crank Arm Installation

Remove the flat head screw located on the

crank shaft with the 2.5mm wrench provided.

Slide the crank handle over the crank shaft

while aligning the holes. Replace the flat-

head screw.