Gamma Silhouette Borealis X Z 사용자 설명서 - 페이지 3

{카테고리_이름} Gamma Silhouette Borealis X Z에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma Silhouette Borealis X Z 18 페이지. Led moving wash/beam

Introduction and Setup

Thank you for choosing the Borealis X Z from GAMMA LED Vision. You will see you have

acquired a powerful and versatile moving light.

Inside the box you should find:

•

Borealis X Z Fixture:

•

Omega Brackets

•

DMX Cable

•

1m PowerCon to Edison Cable

(Flight case, Safety cable and Clamps are optional, please contact your dealer)

Please check carefully that there is no damage from shipping. Should there be any problems,

please consult your dealer and don't use the light until you've verified it's good to go!

Before installation, please read the user manual carefully, then prepare Omega Brack-

ets (2 pcs), Clamps (2 pcs), and Safety Cable (1 pc).

Clamp Mounting: The Silhouette Borealis X Z provides a unique mounting bracket assem-

bly that integrates the bottom of the base, and the safety cable rigging point in one unit.

When mounting this fixture to truss be sure to secure an appropriately rated clamp to the

included omega bracket using a M10 screw fitted through the center hole of the omega

bracket.

As an added safety measure be sure to attached at least one properly rated safety cable

to the fixture using on of the safety cable rigging point integrated in the base assembly.

 Extremely small, fast and powerful LED moving head.

 540º Pan and 270º Tilt

 DMX Channels: 10CH, 15CH, 21CH, 37CH, and 39CH

 Ring Control in 3 Segments

 10º -60º Zoom

 Strobe 1-20hz

 DMX Control

 Quiet Motors and Fans

Silhouette Borealis X Z – GAMMA LED Vision

Page 3 of 18