Gamma Progression ST II 소유자 매뉴얼 - 페이지 14

{카테고리_이름} Gamma Progression ST II에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma Progression ST II 19 페이지.
Gamma Progression ST II에 대해서도 마찬가지입니다: 소유자 매뉴얼 (17 페이지)

페이지 인쇄

MAINTENANCE & ADJUSTMENTS

Adjusting the Tensioner Brake

After stringing many racquets, the brake

of the tensioner may need to be adjusted.

With the brake lever engaged in the latch,

insert the 5mm allen wrench into the bolt (A)

located at the base of the brake lever. It can be

accessed through the hole on the face of the

tensioner cover (above the 'GAMMA' logo).

Note: The tensioner cover does not need to

be removed for the adjustment. The cover

has been removed in the pictures for illustra-

tion purposes.

While holding the 5mm brake lever adjust-

ment bolt (A), loosen the hex bolt (B) located

on the back side of the tensioner frame with

the 4 mm allen wrench.

Note: The hex bolt should only be loosened

and must not be completely removed.

To tighten the braking mechanism, turn the

set screw (A) counter clockwise by about 1/8

turn. Re-tighten the allen screw (B) on the

back side of the tensioner frame and check

for brake tightness. The tensioner should

move freely along the track with the brake

lever engaged and should hold tension with

the brake lever released. If more adjustment

is needed, repeat steps above until properly

adjusted.