Gamma Progression ST II 소유자 매뉴얼 - 페이지 5

{카테고리_이름} Gamma Progression ST II에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma Progression ST II 19 페이지.
Gamma Progression ST II에 대해서도 마찬가지입니다: 소유자 매뉴얼 (17 페이지)

페이지 인쇄

ASSEMBLY INSTRUCTIONS

Support Post Installation (cont'd)

Place the support post onto the central slot

of the turntable. With your ﬁ ngers placed

through the large hole in the underside of the

turntable, press the mounting plate against

the inside top surface of the turntable while

aligning the hole in the support post with the

hole in the mounting plate and ﬁ x them with

the mounting bolt. Repeat procedure on to

attach the support post on the opposite side

of the turntable.

Clamp Head Installation

The post of the string clamp head and tube of

the string clamp base are treated with grease

to provide protection against corrosion during

shipping. Remove any excessive grease with

a clean cloth prior to use. The post and tube

may also be cleaned with isopropyl alcohol.

After this type of thorough cleaning, the post

and tube should be treated with a light coating

of machine oil to protect the surfaces against

corrosion and to ensure smooth operation.

Installing the Tensioner

Remove the button head screw and washer

located at the end of the tensioner bar with

the 3mm hex wrench provided. Slide the

tensioner onto the bar, being careful to align

the bar with all of the bearings and the drive

gear with the gear track. Replace the screw

and washer into the end of the tensioner bar.

Note: The tensioner bar is equipped with

a tensioner travel stop to limit travel of the

tensioner along the bar. See page 10 for

more details about this feature.