Gamma X-Stringer XLT 소유자 매뉴얼 - 페이지 10

{카테고리_이름} Gamma X-Stringer XLT에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma X-Stringer XLT 20 페이지. Electronic stringing machine

STRINGING THE FRAME

Clamp Base Operation

To lock the string clamp base to the turntable,

rotate the clamp base locking lever clockwise.

To release the string clamp base from the

turntable, rotate the clamp base locking lever

counter-clockwise.

The Locking Lever should be tightened enough

to prevent clamp base slippage on the turntable,

when the desired tension is placed on the string.

String Clamp Operation

The string c

lamps are a dual action design

where the string clamp and clamp base oper-

ate independently of one another.

To clamp a string, lift the string clamp to place

the string between the jaws and depress the

string clamp lever to secure the string. The

clamping pressure applied to the string should

be adjusted to provide suﬃ cient pressure

to secure the string when subjected to the

desired pulling tension. The textured gripping

surfaces on the teeth of the string clamps

provide for increased friction between the

clamps and the string to allow for reduced

clamping pressure while securing and holding

the string under tension.

Note that excessive pressure can damage

both the strings and String Clamp.

Getting Started

To begin stringing the main strings, thread

the two ends of the string through the two

center holes at the appropriate end of the

frame and continue through the opposite

center holes. Thread one end of the string

through the adjacent grommet hole and pull

excess by hand.

Secure one of the strings using a string clamp.