Gamma X-Stringer XLT 소유자 매뉴얼 - 페이지 17

{카테고리_이름} Gamma X-Stringer XLT에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma X-Stringer XLT 20 페이지. Electronic stringing machine

TROUBLESHOOTING TIPS

PROBLEM

String slips in clamps

String slips in gripper

String clamp base slips on turntable

Electrical system does not function

String tension too tight or too loose

With time and use, the clamping surfaces of your machine may become oily or dirty and result

in string or clamp slippage while stringing. Periodic cleaning of the String Clamps, String Clamp

Base and String Gripper is recommended. Knife sharpening stones work well for cleaning the

diamond coated string clamping surfaces. Cleaning with a solvent such as isopropyl alcohol

and a mild abrasive tool such as a toothbrush also works well to remove oily or greasy build up.

- Adjust gap between clamp jaws

- Clean clamp jaws

- Clean gripper jaws

- Make sure string is wrapped over top gripper

prior to inserting between gripper jaws

- Clean bottom of clamp & top of turntable with

alcohol

- Adjust clamp base locking nut

- Check power source

- Check power cord connections

- Check tension using a tension calibrator,

adjust machine calibration if necessary

CARE & CLEANING

SOLUTION