Major tech MT1883 사용 설명서 - 페이지 13

{카테고리_이름} Major tech MT1883에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Major tech MT1883 16 페이지.

Insert the temperature probe into the negative jack (COM) and

the positive jack (Temperature), making sure to observe the

correct polarity.

Touch the temperature probe head to the part whose

temperature you wish to measure. Keep the probe touching the

part under test until the reading stabilises (about 30 seconds)

Read the temperature on the display. The digital reading will

indicate the proper decimal point and value.

Warning: To avoid electric shock, be sure the thermocouple has been

removed before changing to another measurement

function.

5. Replacing the Battery

Warning: To avoid electric shock, disconnect the test leads from any

source of voltage before removing the battery cover.

When the battery becomes ﬂat or drops below the operating

voltage, "BAT" will appear in the right-hand side of the LCD

display. The battery should be replaced.

Follow instructions for installing the battery. See the battery

installation section of the manual.

Dispose of the old battery properly

Warning: To avoid electric shock, do not operate your meter until the

battery cover is in place and fastened securely.

Warning: To avoid electric shock, disconnect the test leads from any

source of voltage before removing the battery cover.

Disconnect the test leads from the meter.

Open the battery cover by loosening the screw using a phillips

head screwdriver.

Insert the battery into battery holder, observing the correct

polarity

Put the battery cover back in place. Secure with the screw

Warning: To avoid electric shock, do not operate the meter until the

battery cover is in place and fastened securely.