HIKVISION DS-2CE16D8T-IT3 사용자 설명서 - 페이지 6

{카테고리_이름} HIKVISION DS-2CE16D8T-IT3에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKVISION DS-2CE16D8T-IT3 15 페이지. Turret cameras turbo hd d8t series
HIKVISION DS-2CE16D8T-IT3에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (17 페이지), 사용자 설명서 (15 페이지)

페이지 인쇄
HIKVISION DS-2CE16D8T-IT3 사용자 설명서
Figure 2-4 Secure the Camera with Mounting Base
8. Connect the corresponding cables, such as power
cord, and video cable.
9. Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
not, adjust the camera according to the figure below
to get an optimum angle.
Pan Position
[0° to 360°]
Tilt Position
[0°to 75°]
1). Hold the camera body and rotate the enclosure
to adjust the pan position [0° to 360°].
2). Move the camera body up and down to adjust
the tilt position [0° to 75°].
3). Rotate the camera body to adjust the rotation
position [0° to 360°].
2.1.2 Mounting with Inclined Base
Steps:
1. Paste the drill template (supplied) to the place
where you want to install the camera.
2. Drill screw holes, and the cable hole on the
ceiling/wall according to the supplied drill template.
3. Disassemble the inclined base by the screw driver.
4. Install the turret camera's mounting base on the
inclined base cover with three PM4 screws.
Figure 2-7 Install Turret Camera's Mounting Base
5. Install the inclined base's body on the ceiling/wall
with four PA4 × 25 screws, as shown in Figure 2-8.
Figure 2-5 3-axis Adjustment
Figure 2-6 The Drill Template
Rotation Position
[0°to 360°]