Makita 4340CT 사용 설명서 - 페이지 7

{카테고리_이름} Makita 4340CT에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 4340CT 17 페이지. Jig saw
Makita 4340CT에 대해서도 마찬가지입니다: 사양 (2 페이지), 사용 설명서 (13 페이지), 기술 정보 (16 페이지)

Makita 4340CT 사용 설명서
3
1
2
1. Blade clamp
2. Jig saw blade
3. Protrusions
1
1. Jig saw blade
1
1. Base
2. Hex wrench

OPERATION

1
2
1. Cutting line
2. Base
Keeping that situation, insert the saw blade into the blade clamp as far as the
001910
two protrusions of the blade can not be seen.
Return the tool opener to its original position.
After installing, always make sure that the blade is securely held in place by
trying to pull it out.
CAUTION:
Do not open the tool opener excessively, or it may cause tool damage.
To remove the blade, open the tool opener to the position shown in the figure.
001911
Pull the saw blade out toward the base.
NOTE:
Occasionally lubricate the roller.
Hex wrench storage
001912
When not in use, the hex wrench can be conveniently stored.
2
CAUTION:
Always hold the tool base flush with the workpiece. Failure to do so may
cause blade breakage, resulting in a serious injury.
Turn the tool on and wait until the blade attains full speed. Then rest the tool
001913
base flat on the workpiece and gently move the tool forward along the previ-
ously marked cutting line. When cutting curves, advance the tool very slowly.
7