Makita 4340CT Instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Elektronarzędzie Makita 4340CT. Makita 4340CT 17 stron. Jig saw
Również dla Makita 4340CT: Specyfikacje (2 strony), Instrukcja obsługi (13 strony), Informacje techniczne (16 strony)

Drukuj stronę

1. Blade clamp

2. Jig saw blade

3. Protrusions

1. Jig saw blade

1. Base

2. Hex wrench

OPERATION

1. Cutting line

2. Base

Keeping that situation, insert the saw blade into the blade clamp as far as the

001910

two protrusions of the blade can not be seen.

Return the tool opener to its original position.

After installing, always make sure that the blade is securely held in place by

trying to pull it out.

CAUTION:

•

Do not open the tool opener excessively, or it may cause tool damage.

To remove the blade, open the tool opener to the position shown in the figure.

001911

Pull the saw blade out toward the base.

NOTE:

•

Occasionally lubricate the roller.

Hex wrench storage

001912

When not in use, the hex wrench can be conveniently stored.

CAUTION:

•

Always hold the tool base flush with the workpiece. Failure to do so may

cause blade breakage, resulting in a serious injury.

Turn the tool on and wait until the blade attains full speed. Then rest the tool

001913

base flat on the workpiece and gently move the tool forward along the previ-

ously marked cutting line. When cutting curves, advance the tool very slowly.