Makita 4340CT Інструкція з експлуатації - Сторінка 7
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Електроінструмент Makita 4340CT. Makita 4340CT 17 сторінок. Jig saw
Також для Makita 4340CT: Технічні характеристики (2 сторінок), Інструкція з експлуатації (13 сторінок), Технічна інформація (16 сторінок)
![Makita 4340CT Інструкція з експлуатації](/uploads/products/server2/2092053/2092053.png)
3
1
2
1. Blade clamp
2. Jig saw blade
3. Protrusions
1
1. Jig saw blade
1
1. Base
2. Hex wrench
OPERATION
1
2
1. Cutting line
2. Base
Keeping that situation, insert the saw blade into the blade clamp as far as the
001910
two protrusions of the blade can not be seen.
Return the tool opener to its original position.
After installing, always make sure that the blade is securely held in place by
trying to pull it out.
CAUTION:
•
Do not open the tool opener excessively, or it may cause tool damage.
To remove the blade, open the tool opener to the position shown in the figure.
001911
Pull the saw blade out toward the base.
NOTE:
•
Occasionally lubricate the roller.
Hex wrench storage
001912
When not in use, the hex wrench can be conveniently stored.
2
CAUTION:
•
Always hold the tool base flush with the workpiece. Failure to do so may
cause blade breakage, resulting in a serious injury.
Turn the tool on and wait until the blade attains full speed. Then rest the tool
001913
base flat on the workpiece and gently move the tool forward along the previ-
ously marked cutting line. When cutting curves, advance the tool very slowly.
7