BERNSTEIN G30013A 조립 지침 매뉴얼 - 페이지 13

{카테고리_이름} BERNSTEIN G30013A에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. BERNSTEIN G30013A 16 페이지. Support frame

SUPPORT FRAME G30013A

Loosen the cross bar support height adjustment bolts.

Raise the cross bar support up as high as possible (under

the waste outlet elbow) and retighten both bolts.

This will provide extra support for the bidet.

Connect the hot and cold pipework to the inlet elbows (Ø

½"), screw the blanking plugs into the outlets.

BSP female threaded outlets may need extending

(depending on tile thickness etc), using male nipples.

The hot and cold inlet elbows can be rotated to suit your

pipework. It is essential that isolation valves are fitted in the

void at this point.

Loosen the hot and cold inlet elbows (using the nut at the

rear).

Set to the required distance apart to allow easy connection

of the mixer supplies within the shroud of the bidet and

retighten.

Build the partition wall, making the holes for the bolts and

pipes.

If required, tile the surface or apply the finish now.