Garaventa Lift EVACU-TRAC CD7 소유자 매뉴얼 - 페이지 15

{카테고리_이름} Garaventa Lift EVACU-TRAC CD7에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garaventa Lift EVACU-TRAC CD7 20 페이지. Emergency evacuation chair

1. Loosen the Rear Brake Cable

Sleeve lock nuts and adjust

their location on the

Positioning Screw to provide

approximately 13 mm (1/2 in)

of free movement in the

Brake Release Bar. This is

the amount of motion that

should occur when squeezing

the Brake Release Bar before

any movement of the Brake

Cable occurs. If more

adjustment is required you

can also use the Cable

Sleeve Positioning Screw at

the other end of the Cable

Sleeve, near the Brake

Release Bar. Tighten the

lock nuts after adjustment.

2. When you squeeze the Brake

Release Bar it should travel

until it just makes contact with

the lime green Handle. This

will allow you to comfortably

hold Brake Release Bar in its

released position when

pushing Evacu-Trac on flat

surfaces or descending a

stairway.

The Brake Release Bar travel

range is adjusted using the

Adjusting Screws that control

the Front Auxiliary Wheel

Retracting Arm. Loosen the

lock nuts and adjust as

required. Test the action of

the Brake Release Bar and

then tighten the lock nuts.