Garaventa Lift EVACU-TRAC CD7 소유자 매뉴얼 - 페이지 16

{카테고리_이름} Garaventa Lift EVACU-TRAC CD7에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garaventa Lift EVACU-TRAC CD7 20 페이지. Emergency evacuation chair

3. The final step is to ensure

that the Track Parking Brake

is functioning correctly. It is

designed to stop and hold

rated load on the stairway.

To do this, the Brake Spring

must pull on the Brake

Mechanism without any

resistance from the Brake

Cable. This can happen if the

Front Brake Cable does not

have sufficient slack.

To check this, lay the open

Evacu-Trac on its side.

Locate the Front Brake Cable.

It should have approximately

19 mm (3/4 in) of slack, when

measured vertically from the

reference point shown in the

drawing to the right.

Adjust the cable as required

using the Adjusting Nut on the

Brake Actuation Arm. Tighten

the Adjusting Nut and test the

function of the Brake. It

should stop and hold Evacu-

Trac on the stairway with

rated load. It should also

release fully when the Brake

Release Bar is squeezed all

the way back to the handle,

allowing Evacu-Trac to

descend the stairway at a

comfortable speed, as shown

in the Training Video.