HIKVISION HiLook Series 사용자 설명서 - 페이지 7
{카테고리_이름} HIKVISION HiLook Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKVISION HiLook Series 14 페이지. Smart hybrid light bullet & turret camera
HIKVISION HiLook Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (18 페이지), 사용자 설명서 (18 페이지), 사용자 설명서 (20 페이지), 사용자 설명서 (18 페이지), 사용자 설명서 (13 페이지), 사용자 설명서 (17 페이지)
페이지 인쇄
not, adjust the camera according to the figure
below.
Rotation Position
[0° to 360°]
1). Loosen the trim ring to adjust the pan position
[0° to 360°].
2). Loosen screw A to adjust the tilt position [0° to
180°].
3). Loosen screw B to adjust the rotation position [0°
to 360°].
7. Tighten the trim ring and screws to finish the
installation.
2.1.2 Ceiling/Wall Mounting with Junction Box
Before you start:
You need to purchase a junction box in advance.
Ceiling mounting and wall mounting are similar.
Following steps take wall mounting as an example.
Steps:
1. Paste the drill template for junction box to the place
where you want to install the camera.
2. (Optional) For cement wall, drill the screw holes
with a 5.5 mm drill and insert the supplied wall
plugs.
Figure 2-4 Drill Template for Junction Box
3. (Optional) Drill the cable hole, when the cables are
routed through the wall.
4. Take apart the junction box.
5. Align the screw holes of the camera with those on
the junction box cover. Attach the camera to the
junction box cover with three PM4 × 10 screws.
Figure 2-5 Attach the Camera to the Junction Box Cover
6. Secure the junction box body on the wall with three
PA4 × 25 screws (supplied).
Figure 2-3 3-Axis Adjustment
Pan Position
[0° to 360°]
Trim Ring
Tilt Position
[0° to 180°]
Screw A
Screw B