Jandy AquaLink RS series 설치 매뉴얼 - 페이지 8
{카테고리_이름} Jandy AquaLink RS series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Jandy AquaLink RS series 16 페이지. Dual equipment systems
페이지 인쇄
- 1. Section 2. System Overview
- 2. Plumbing Diagrams
- 3. Connecting Power and Mounting Bezel
- 4. Connecting Control Panel Cable to Pcb
- 5. Section 3. Power Center Connection (Low Voltage)
- 6. Dip Switch Functions
- 7. Dip Switch Settings for Pool and Spa Combination
- 8. Section 5. Dual Equipment Wiring Diagram
Page 8
2.3
Plumbing Diagrams
2.3.1 Basic Plumbing
Refer to Figure 1 when plumbing two separate
sets of equipment. The basic setup consists of one
pump, filter and heater for the pool and another set
for the spa.
Pool Heater
Pool Return
Figure 1.
Basic Plumbing for Dual Equipment
2.3.2 Plumbing - Sharing One heater
When the system setup is using only one heater,
plumb the equipment as shown in Figure 2.
Please note that for this type of plumbing a new
bezel decal must be applied over the existing decal
in order to identify the correct labeling for the
HEATER and VALVE buttons.
RESET
AUTO
SERVICE
TIME OUT
Dual Equipment with
Shared Heater Bezel decal
4 3 2 1
4 3 2 1
S1
RESET
AUTO
SERVICE
TIME OUT
S2
Figure 2.
Dual Equipment System with One heater
Pool
Pump
Pool Filter
Check
Valve
(Optional)
Pool Intake
6 5 4 3 2 1
10 9 8 7 6 5 4 3 2 1
Spa Heater
Spa Return
NOTE When connecting to the AquaLink RS, plug
the JVAs into the Intake, Return and Cleaner
JVA sockets. Slide DIP Switch S1-6 to the
ON position. See wiring diagram in Section 4,
Figure 5.
From Solar
(if installed)
JVA
Shared Heater
Check
Valves
(4)
Return
Spa
Pump
Spa Filter
Check
Valve
(optional)
Spa Intake
To Solar
(if installed)
Pool Return
JVA
Pool Filter
JVA
Spa
Spa Filter
Pool
Pump
Pool
Intake
Spa
Pump
Spa
Intake