Brizo SENSORI T66T0 Series 매뉴얼 - 페이지 3

{카테고리_이름} Brizo SENSORI T66T0 Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brizo SENSORI T66T0 Series 20 페이지. Thermostatic valve trim
Brizo SENSORI T66T0 Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (8 페이지), 매뉴얼 (8 페이지)

페이지 인쇄

Note: The Sensori

rough (R66000-WS) must be installed before

installing the trim.

Turn off water supplies from main or

inlet stops (1). Remove

plasterguard (2), bonnet nut (3) and test cap

(4) from the body.

Verify presence of either o-ring (on some

models) or friction bushing (4) located on

splined valve stem.

Locate flats (1) on cartridge (2) and inside

of sleeve (3). Align flats and insert cartridge

into sleeve being careful not to push on

copper element at end of cartridge.

R66000-WS

Thermostatic Valve

Locate "V" (1) on cartridge sleeve and "V"

notch (2) on valve body (3). Align the "Vs"

and press sleeve and cartridge assembly

(4) into valve body (3) and note the "UP"

position (5).

Slide bonnet nut (1) over the cartridge and

thread onto the body.

Hand tighten securely.

102224 Rev. C