Brizo SENSORI T66T0 Series Manuel - Sayfa 3

Kontrol Ünitesi Brizo SENSORI T66T0 Series için çevrimiçi göz atın veya pdf Manuel indirin. Brizo SENSORI T66T0 Series 20 sayfaları. Thermostatic valve trim
Ayrıca Brizo SENSORI T66T0 Series için: Hızlı Başlangıç Kılavuzu (8 sayfalar), Manuel (8 sayfalar)

Sayfayı Yazdır

Note: The Sensori

rough (R66000-WS) must be installed before

installing the trim.

Turn off water supplies from main or

inlet stops (1). Remove

plasterguard (2), bonnet nut (3) and test cap

(4) from the body.

Verify presence of either o-ring (on some

models) or friction bushing (4) located on

splined valve stem.

Locate flats (1) on cartridge (2) and inside

of sleeve (3). Align flats and insert cartridge

into sleeve being careful not to push on

copper element at end of cartridge.

R66000-WS

Thermostatic Valve

Locate "V" (1) on cartridge sleeve and "V"

notch (2) on valve body (3). Align the "Vs"

and press sleeve and cartridge assembly

(4) into valve body (3) and note the "UP"

position (5).

Slide bonnet nut (1) over the cartridge and

thread onto the body.

Hand tighten securely.

102224 Rev. C