Lexmark CS410 series 빠른 참조 매뉴얼 - 페이지 2

{카테고리_이름} Lexmark CS410 series에 대한 빠른 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Lexmark CS410 series 11 페이지. Color laser printer
Lexmark CS410 series에 대해서도 마찬가지입니다: 기술 노트 (3 페이지), 설정 시트 (2 페이지), 매뉴얼 (19 페이지), 인쇄 매뉴얼 (8 페이지), 빠른 참조 매뉴얼 (14 페이지), 색 품질 매뉴얼 (6 페이지), 연결 매뉴얼 (6 페이지), 종이 매뉴얼 (4 페이지), 메뉴 맵 (2 페이지), 이동 매뉴얼 (2 페이지), 정보 매뉴얼 (1 페이지), 데이터시트 (2 페이지), 데이터시트 (2 페이지), 서비스 매뉴얼 (18 페이지)

Press the up or down arrow button to select the paper type, and

then press

Configuring Universal paper settings

The Universal paper size is a user‑defined setting that lets you print on

paper sizes that are not preset in the printer menus.

Notes:

•

The smallest supported Universal size is 76 x 127 mm (3 x 5

inches) and is loaded only in the multipurpose feeder and

manual feeder.

•

The largest supported Universal size is 215.9 x 359.9 mm (8.5 x

14.17 inches) and is loaded only in the multipurpose feeder and

manual feeder.

From the printer control panel, navigate to:

> Settings >

> Paper Menu >

> Units of Measure >

> select a unit of measure >

Press the up or down arrow button until Portrait Height or

Portrait Width appears, and then press

Enter the preferred settings using the keypad or press the left or

right arrow button to manually select the size you want, and then

press

Press

Loading the 250‑ and 550‑sheet tray

The printer has one 250-sheet tray (Tray 1) with an integrated manual

feeder. The 250-sheet tray, the 650-sheet duo tray, and the 550-sheet

tray support the same paper sizes and types and are loaded in the same

way.

CAUTION—POTENTIAL INJURY: To reduce the risk of

equipment instability, load each tray separately. Keep all other

trays closed until needed.

Pull out the tray completely.

Note: Do not remove trays while a job is printing or while Busy

appears on the display. Doing so may cause a jam.

If the paper is longer than letter‑size paper, then squeeze and then

slide the length guide at the back of the tray to extend it.

> Universal Setup >

Squeeze, and then slide the length guide tab to the correct position

for the size of the paper being loaded.

Note: Use the paper size indicators on the bottom of the tray to

help position the guide.