Lexmark J 110 Appletalk 매뉴얼 - 페이지 4

{카테고리_이름} Lexmark J 110에 대한 Appletalk 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Lexmark J 110 14 페이지. Appletalk and marknet print servers
Lexmark J 110에 대해서도 마찬가지입니다: 빠른 참조 (2 페이지), 개요 (1 페이지)

페이지 인쇄

Printing

Print materials

Supplies

Troubleshooting

Administration

Set the IP address using the printer operator panel

A simple way to set the IP address, netmask and gateway inside the print server is to use the

printer operator panel. You need to be standing at the printer to use this method.

On the printer operator panel, choose Parallel Menu, STD Parallel, Network 0 Setup,

TCP/IP, Set IP Address. Press Menu> until you see the correct menu item, and then

press Select.

When the current IP address is displayed, use the buttons to change the address.

Note: Pressing Select advances you to the next segment in the address. Menu>

increases the number by one. <Menu decreases the number by one.

When you finish setting the IP address, press Select until the word SAVED appears

briefly.

Set the IP netmask and gateway in a similar way.

Print a network setup page to verify the parameters are set as you intended.

www.lexmark.com

AppleTalk and MarkNet print servers

Lexmark J110