Align-Pilates Combo Chair II 조립 지침 및 사용자 설명서 - 페이지 8

{카테고리_이름} Align-Pilates Combo Chair II에 대한 조립 지침 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Align-Pilates Combo Chair II 12 페이지.

13) Insert the 2 x Jump Board fasteners (29) into place. Then, attach the 2 x Short eyelet bolts (37)

in the 2 holes in the front of the Base Frame with Wheels (6) in a vertical position, as shown in Fig.

15.

14) To assemble the two-part handles slide the 2 x Black Upper Handles (16) over the 2 x Chrome

Height Adjustment Bars for Handles (17) and secure with 6 x Short bolts with loctite & washers (45).

Tighten fully.

15) Slide the assembled handles into the handle holders, 1 on each side, then insert the 2 x Twist

& pull height adjustment knobs (28). To adjust: pull out the Twist & Pull knob, move the handle to

the correct height, let go of the knob to allow the locking pin to locate in to one of the 9 holes.

Once located at the desired height, tighten the knob to prevent rattle and to fully secure the

handles.

16) Finally, before first use go over the Combo Chair II and ensure that all bolts have been

properly tightened then your Align-Pilates Combo Chair II is complete!

Fig.14

Fig.13

2 x Small eyelet bolts

with washers & nuts (37)