AEG 49669GO-MN 사용자 설명서 - 페이지 36

{카테고리_이름} AEG 49669GO-MN에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG 49669GO-MN 38 페이지. 90cm

tEstING tHE opErAtIoN of tHE GAs cookEr

NOTE: You MUST test the cooker after installation,

before you hand it over to the customer. You MUST

have a manometer and a connecting tube.

checking gas supply

1 . turn on the gas supply and the electricity and try to

ignite the gas .

NOTE: It will take additional time to light the gas for

the first time as air needs to be purged from the pipes.

testing the cooker features

• O bserve the flame appearance on each burner. If

it is much smaller or larger than expected, then the

injector size needs checking .

NOTE: When flame is unsatisfactory, then refer to the

Electrolux Technical Publications and correct the fault,

if possible.

when maximum flame appearance is correct, then

check the turn-down setting on each burner . If the

settings appear to be incorrect, proceed as follows:

1 . adjust the bypass screw mounted on the body of

each hotplate control cock . this is accessible when

the control knob and the control panel are removed .

2 . check the ignition on all burners both separately

and in combination .

3 . check the operation of the electrical components,

if applicable .

4 . If you are satisfied that the cooker is operating

correctly, then turn it off and show the customer how

to use it . Make sure you ask the customer to operate

the clock and controls .

NOTE: If the cooker cannot be adjusted to perform

correctly, then inform the customer of the problem and

put a warning notice on the cooker. If the problem is

dangerous, then disconnect the cooker. If there is a

fault, then the customer should be advised to contact

the manufacturer's local service organisation.