AEG 49669GO-MN 사용자 설명서 - 페이지 35

{카테고리_이름} AEG 49669GO-MN에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG 49669GO-MN 38 페이지. 90cm

NAtUrAl GAs coNVErsIoN

Model 49669Go-MN

this appliance is supplied set up to for lpG usage . a

conversion kit is included with the product for natural

gas usage . the conversion kit contains 6 injectors and

natural gas sticker .

please follow the procedure below if a conversion to

suit natural gas is required .

1 . remove the hotplate trivets, burner caps and burner

crowns to access the hotplate injectors . replace the

factory fitted injectors with the appropriate injectors,

as supplied . refer to injector orifice table for injector

sizes . the injector size is stamped on the side of

the injector .

2 . turn on the gas supply and at each new connection

check for leaks using soapy water: each hotplate

valve should be turned on, one at a time, and the

injector hole blanked off for several seconds .

3 . One by one, turn the knobs to minimum and adjust

the bypass screw (accessible when the knob is

removed) until a small stable flame results . turn the

knob to maximum and then back to minimum to

ensure that the correct minimum flame

is maintained .

4 . attach the natural gas sticker to the cooker, near

the gas supply inlet . cover the lpG label that is

factory fitted .

flame size adjusted to maximum

flame size adjusted to minimum

Bypass screw

control knob shaft