Garmin 500W Series 사용 설명서 - 페이지 9

{카테고리_이름} Garmin 500W Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin 500W Series 26 페이지. Continued airworthiness
Garmin 500W Series에 대해서도 마찬가지입니다: 파일럿 매뉴얼 부록 (24 페이지), 추가 비행 매뉴얼 (17 페이지), 파일럿 매뉴얼 부록 (50 페이지), 빠른 참조 (25 페이지), 사용 설명서 (11 페이지), 사용 설명서 (23 페이지)

The installed 400W Series equipment can be accessed as described below:

LRU Access: Bell models 407

1. GA 35/36/37 ANTENNA: FS84.0 for dual antenna installation; FS79.0 for single antenna installations.

Remove environmental seal, remove four antenna screws and lift the antenna enough to disconnect

antenna connector.

2. OVERHEAD CIRCUIT BREAKER PANEL: Access or remove by extracting the mounting screws along

the side of the circuit breaker panel.

3. CYCLIC CONTROL GRIPS: remove by extracting mounting screw at bottom of grip.

4. COOLING FAN: FS24.63 Access by removing 407-030-202-148 COVER, LOWER, RH. Remove two

screws, disconnect connector and air duct.

5. 400W SERIES UNIT: FS40 Access or remove by using a 3/32 allen head screwdriver to loosen the

locking mechanism through the access hole on the front of the unit. Note: location may vary slightly

depending whether or not a dual navigator system is installed.

400W Series

Instructions for Continued Airworthiness Bell 407

190-01226-14 Rev. 3

Page 9 of 26