Garmin 500W Series Руководство по эксплуатации - Страница 9

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для GPS Garmin 500W Series. Garmin 500W Series 26 страниц. Continued airworthiness
Также для Garmin 500W Series: Дополнение к руководству пилота (24 страниц), Дополнительное руководство по летной эксплуатации (17 страниц), Дополнение к руководству пилота (50 страниц), Краткая справка (25 страниц), Руководство по эксплуатации (11 страниц), Руководство по эксплуатации (23 страниц)

The installed 400W Series equipment can be accessed as described below:

LRU Access: Bell models 407

1. GA 35/36/37 ANTENNA: FS84.0 for dual antenna installation; FS79.0 for single antenna installations.

Remove environmental seal, remove four antenna screws and lift the antenna enough to disconnect

antenna connector.

2. OVERHEAD CIRCUIT BREAKER PANEL: Access or remove by extracting the mounting screws along

the side of the circuit breaker panel.

3. CYCLIC CONTROL GRIPS: remove by extracting mounting screw at bottom of grip.

4. COOLING FAN: FS24.63 Access by removing 407-030-202-148 COVER, LOWER, RH. Remove two

screws, disconnect connector and air duct.

5. 400W SERIES UNIT: FS40 Access or remove by using a 3/32 allen head screwdriver to loosen the

locking mechanism through the access hole on the front of the unit. Note: location may vary slightly

depending whether or not a dual navigator system is installed.

400W Series

Instructions for Continued Airworthiness Bell 407

190-01226-14 Rev. 3

Page 9 of 26