Brother 2340CV 서비스 매뉴얼 - 페이지 4
{카테고리_이름} Brother 2340CV에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother 2340CV 16 페이지. User manual - french and nederlands
Brother 2340CV에 대해서도 마찬가지입니다: 운영 매뉴얼 (40 페이지), (프랑스어) 마누엘 디렉션 (41 페이지)
페이지 인쇄
- 1. Table of Contents
- 2. How to Use this Manual
- 3. How to Adjust
- 3. Height of Needle Bar
- 3. Position of the Lowerlooper
- 3. Timing of the Double Chain Looper
- 3. Timing of the Lowerlooper
- 3. Height of Feed Dog (with a Differential Feed Dog)
- 3. Feed Timing
- 3. Height of Presser Bar
- 3. Thread Tension Adjustment
- 3. Position of Thread Take-Up
- 3. Position of Looper Thread Take-Up
- 3. Adjustment and Replacement for the Timing Belt
- 3. Changing the Light Bulb
HOW TO ADJUST......
2
Needle plate
Needle descents
1. Raise the needle to its highest position.
2. Loosen the screw on the needle bar.
3. Position the needle bar so that the clearance between the point of the needle and the surface of the needle plate is
as follows:
5.8 - 6.2 mm
NOTE • When making this adjustment, keep the needle bar at its highest position by holding the handwheel. Use the
left needle of the three needles to adjust the height. After completing adjustment, check that the needle
lowers to the center of the needle descents.
PARTS CODE FOR GAUGE: XB1282001
Height of needle bar
3
How to use the gauge
1
Left needle
(Three needle models)
3
5.8 - 6.2 mm
SCHMETZ
130/705H #90
3