Garmin G3000 사용 설명서 - 페이지 14

{카테고리_이름} Garmin G3000에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin G3000 18 페이지. Swapping gsa80 roll & gsa80 yaw servo on citation cj3+

Section 3

Final Verification / Return to Service

• Review the options that were determined to be installed per section 1.

• Compare that to the tables in Section 4.

o Write the Expected FLEET ID in the table below.

• Turn power on.

• Select Home on either GTC controller.

o Select Utilities.

o Select Setup.

o Select Avionics Status.

o Select the LRU Info tab on the left side.

 Verify that all the LRUs are showing green check mark.

o Select the Airframe tab on the left side.

o Verify that the FLEET ID matches the number determined in Section 4 based on

the options installed in the aircraft.

EXPECTED FLEET ID (from Section 4 of this document)

 Ensure that the Expected and Actual FLEET IDs match.

o Select the MSG button:

 Verify there is no DB Mismatch message present.

 Verify there is no Manifest message present.

 Verify there is no Config message present.

Version 1.0

REFERENCE ONLY

ACTUAL FLEET ID