Garmin GTS 8000 교체 - 페이지 8

{카테고리_이름} Garmin GTS 8000에 대한 교체을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin GTS 8000 16 페이지. For citation m2, garmin g3000 software version 10
Garmin GTS 8000에 대해서도 마찬가지입니다: 파일럿 매뉴얼 (26 페이지)

페이지 인쇄
Garmin GTS 8000 교체
Section 4

Final Verification / Return to Service

Note: This is with the G3000 powered up in normal mode.
• Determine options installed using Appendix A.
• Select Home on the left GTC controller.
o Select Utilities.
o Select Setup.
o Select Avionics Status.
o Select the Airframe tab on the left side.
o Verify that the configuration ID (CRC Number) matches the number determined in
Appendix B based on the options installed in the aircraft.
o Select the LRU Info tab on the left side.
 Verify that all the LRUs are showing green check mark.
o Select the MSG button:
 Verify there is no DB Mismatch message present.
 Verify there is no Manifest message present.
 Verify there is no Config message present.
• If the initial radar trims were not zero:
o Select Home on the left GTC controller.
o Select Aircraft Systems.
o Select Maintenance.
o Enter password CACCDMS.
o Select Radar Trim.
Return to Service Testing
For testing, complete section 7.17.1 in the Garmin G3000 LMM.
•
Version 1.0
Enter the Pitch and Roll trims recorded in section 1.
8