Garmin Fishfinder 400C 소유자 매뉴얼 - 페이지 29
{카테고리_이름} Garmin Fishfinder 400C에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin Fishfinder 400C 40 페이지. Flush mount kit instructions and template (multilingual)
Garmin Fishfinder 400C에 대해서도 마찬가지입니다: 빠른 참조 매뉴얼 (2 페이지), 중요 안전 정보 (48 페이지), 적합성 선언 (1 페이지), 설치 지침 매뉴얼 (28 페이지), 설치 지침 매뉴얼 (30 페이지), 소유자 매뉴얼 (21 페이지)
페이지 인쇄
Changing the System Settings
To change the system settings, on the Configure screen, highlight
System, and press SElECt.
beeper—set when the unit makes audible sounds. The three settings
are Off, Alarms Only (default), and On (keys and alarms).
Simulator—turn on the Simulator to have the Fishfinder 400C act as
though a transducer is connected.
NMEA Output— connect the Fishfinder 400C to NMEA compatible
electronic equipment (such as a Garmin GPS device) and send
information. To do so, you must change this setting to On. For more
information on connecting to a NMEA device, see
language—select the on-screen language.
System Information—view the current operating software version
and your unit's unique internal unit ID.
Factory Settings—reset the Fishfinder 400C to the factory settings.
You are prompted to confirm your choice to restore all factory
settings. Choose yes. Otherwise, choose No to retain your current
configuration.
Fishfinder 400C Owner's Manual
Configuring Transducer Settings
To change the transducer settings, on the Configure screen, highlight
transducer, and press SElECt.
type—select the transducer type (Dual Frequency or Dual beam).
Keel Offset —offset the surface reading for the depth of a keel so
you can measure depth from the bottom of your keel instead of from
the transducer's location. Enter a positive number to offset for a keel.
You can enter a negative number to compensate for a large vessel
that may draw several feet of water.
Transducer at Surface
page
12.
Transducer at Bottom
Enter (-) negative number to
show depth from the surface.
c
Enter (+) positive
number to show depth
from the bottom of keel.
of Keel
F
400c
ustomIzIng the
IshFInder