Garmin FUSION Apollo MS-WB670 소유자 매뉴얼 - 페이지 32

{카테고리_이름} Garmin FUSION Apollo MS-WB670에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin FUSION Apollo MS-WB670 44 페이지. Marine hideaway stereo
Garmin FUSION Apollo MS-WB670에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (19 페이지)

페이지 인쇄

Speed Source Information

Select

> SETTINGS, select the name of the stereo, then select ZONE > SPEED VS VOLUME > SPEED

SOURCE.

ENGINE SPEED: Uses the RPM reading provided by a supported NMEA 2000 engine. The volume increases

as the engine RPM increases from the set MIN speed to the set MAX speed. If multiple supported engines

are connected, the stereo uses the average RPM reading from all engines.

SPEED OVER GROUND: Uses the speed over ground (SOG) reading provided by a supported NMEA 2000

GPS antenna or chartplotter with an internal GPS antenna. The volume increases as the SOG increases

from the set MIN speed to the set MAX speed.

SPEED THROUGH WATER: Uses the speed through water (STW) reading provided by a supported NMEA

2000 water-speed sensor. The volume increases as the STW increases from the set MIN speed to the set

MAX speed.

WIND SPEED: Uses the wind speed reading provided by a supported NMEA 2000 wind-speed sensor. The

volume increases as the wind speed increases from the set MIN speed to the set MAX speed.

Disabling a Zone

You can disable an unused zone and remove it from the audio level pages. When a zone is disabled, you

cannot change any of the settings for that zone. You cannot disable zone 1.

1 Select

> SETTINGS.

2 Select the name of the stereo.

3 Select ZONE.

4 Select a zone.

5 Select ZONE ENABLED to clear the check box.

Setting a Zone Name

You can set a name for a speaker zone to make it easier to identify.

1 Select

> SETTINGS.

2 Select the name of the stereo.

3 Select ZONE.

4 Select a zone.

5 Select ZONE NAME.

6 Use the on-screen keyboard to enter a name, and select

Linking Zones

You can link zones 1 and 2 to keep the volume levels synchronized. Adjusting the volume of either of the linked

zones affects both zones.

1 Select

> SETTINGS.

2 Select the name of the stereo.

3 Select ZONE > ZONE 2 > LINK TO ZONE 1.

NOTE: After zones 1 and 2 are linked, you cannot adjust the volume of each zone individually.

General Settings