Brother TD-4420TN 사용자 설명서 - 페이지 36

{카테고리_이름} Brother TD-4420TN에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother TD-4420TN 44 페이지. Cutter module
Brother TD-4420TN에 대해서도 마찬가지입니다: 설치 매뉴얼 (2 페이지)

페이지 인쇄

1. Troubleshooting

4.3.5 Media Sensor Calibration (For the Gap Sensor)

1. Turn off the printer.

2. Press and hold the Feed/Pause Button, and then turn on the printer.

3. Release the button after the green/amber LED flashes five times and the LED is lit in

red/amber.

Note

The LED color will change as follows:

Amber  red (5 times)  amber (5 times)  green (5 times)  green/amber (5 times) 

red/amber (5 times)  green (lit)

4.3.6 Skip the AUTO.BAS program

The user can upload the AUTO.BAS program to the printer's flash memory so that it can be run

automatically at startup.

To prevent the AUTO.BAS program from running at startup:

1. Turn off the printer.

2. Press the Feed/Pause Button, and then turn on the printer.

3. Release the button when the LED is lit in green.

Note

The LED color will change in the following order:

Amber  red (5 times)  amber (5 times)  green (5 times)  green/amber (5 times) 

red/amber (5 times)  green (lit)

4. The printer will start without running the AUTO.BAS program.