Fujitsu fi-5220C 시작하기 매뉴얼 - 페이지 24

{카테고리_이름} Fujitsu fi-5220C에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu fi-5220C 29 페이지. Flatbed scanner
Fujitsu fi-5220C에 대해서도 마찬가지입니다: 시작하기 (28 페이지), 설치 절차 매뉴얼 (7 페이지), 설치 절차 매뉴얼 (9 페이지), 설치 절차 (3 페이지), 사양 (2 페이지), 사용 설명서 (13 페이지), 청소 지침 (2 페이지), 청소 지침 (2 페이지)

페이지 인쇄
Fujitsu fi-5220C 시작하기 매뉴얼
Symptom
Paper is not fed (pick error
occurs frequently, or docu-
ment stops midway).
The generated images are
elongated.
There is a shadow on the
leading edge of the gener-
ated image.
AP-2
Check this item
Do the documents satisfy the "Docu-
ment Quality" and the "Multi feed
Detection Conditions" in the chapter 6
of the fi-5530C Operator's Guide?
Is the Pick roller dirty?
Is the Pick roller worn out?
Is there any dirt or dust in the document
feed path?
Are the Feed rollers dirty?
Have you adjusted the scan scale?
Are the Feed rollers dirty?
Have you adjusted the offset (the scan-
ning starting position)?
Remedy
Use the documents that satisfy the "Document
Quality" and the "Multi feed Detection Condi-
tions" in the chapter 6 of the fi-5530C Operator's
Guide.
Clean the Pick roller. Refer to Operator's Guide in
"3.3. Cleaning the ADF".
Change the Pick roller. Refer to Operator's Guide
in "4.3. Replacing the Pick Roller".
Remove any dirt or dust from the document feed
path.
Clean the Feed rollers. Refer to Operator's Guide
in "3.3. Cleaning the ADF".
For Windows 2000, WindowsXP, select "Scan-
ners and Cameras" in the control panel, then click
the [Device Set] tab to adjust scale.
Clean the Feed rollers. Refer to Operator's Guide
in "3.3. Cleaning the ADF".
Adjust the [Sub-scan Setting] on [Scanners and
Cameras] in the control panel.