Fujitsu FI-5900C 시작하기 - 페이지 10

{카테고리_이름} Fujitsu FI-5900C에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu FI-5900C 30 페이지. Consumable replacement and cleaning instructions
Fujitsu FI-5900C에 대해서도 마찬가지입니다: 시작하기 (30 페이지), 설치 절차 매뉴얼 (7 페이지), 설치 절차 매뉴얼 (9 페이지), 설치 절차 (3 페이지), 브로셔 및 사양 (2 페이지), 보충 설명서 (4 페이지), 브로셔 및 사양 (4 페이지), 소모품 교체 및 청소 지침 (24 페이지), 교체 절차 (22 페이지), 청소 지침 (2 페이지)

Fujitsu FI-5900C 시작하기
■ Removable Parts
1
No.
Name
1
Document
smoother
2
3
4
5
No.
Name
2
Pick rollers
Rollers that pick the paper from
the hopper into the ADF. This is a
consumable item.
3
Separator
Rollers used to help separate the
rollers
paper as the feeding begins. This
is a consumable item.
4
Brake roller
Roller used to help separate the
paper as the feeding begins. This
is a consumable item.
5
Pad
Separation Pad used to help sepa-
rate the paper as the feeding
begins. This is a consumable
item.
2
Description
Attached when the stacker posi-
tion is set to align the ejected doc-
ument by the leading edge, or
when scanning documents with
different widths.
Description

1.3 Operator Panel

The operator panel is located on the right side of the
scanner. The panel consists of a Function Number Dis-
play, buttons and a LED.
Name
Shows the status of the scanner.
Function
For details, refer to
Function Number Display" (page
Use these buttons to adjust the height
Hopper Height
of the Hopper to the Upper/Middle/
Lower Positions.
The hopper moves automatically to
the right position after giving a scan-
ning command. However, this may
cause a delay before the actual scan-
ning starts. To avoid unnecessary
waiting time, it is recommended to set
the hopper height prior to scanning.
The approximate loading capacities
are as follows (* these numbers differ
depending on the document thick-
ness):
Upper: 100 sheets
Middle: 300 sheets
Lower: 500 sheets
Use these buttons to adjust the paper
Paper Thickness
Thin
Thick
thickness for the papers to be scanned.
When picking errors or paper jams
occur:
Press the
When multifeed occurs:
Press the
(Normally no need to change from the
default setting)
Use this button to start linked applica-
Send to
tion.
When this button is pressed at manual
feed mode, the scanning stops immedi-
ately
(*About the settings, refer to the "fi-
5900C Operator's Guide" on the Setup
CD-ROM).
Function number display
Function
Hopper Height
Paper Thicknes s
Thin
Thick
Send to
Scan
Function
"Indications on the
3).
(Thin) button.
(Thick) button.