Fujitsu Fujitsu fi-5950 시작하기 - 페이지 22

{카테고리_이름} Fujitsu Fujitsu fi-5950에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu Fujitsu fi-5950 27 페이지. Image scanner
Fujitsu Fujitsu fi-5950에 대해서도 마찬가지입니다: 브로셔 및 사양 (4 페이지), 소모품 교체 및 청소 지침 (24 페이지), 시작하기 (11 페이지)

페이지 인쇄

Symptom

Paper is not fed (pick error

occurs frequently, or docu-

ment stops midway).

The generated images are

elongated.

There is a shadow on the

leading edge of the gener-

ated image.

Check this item

Do the documents satisfy the "Docu-

ment Quality" and the "Multifeed Detec-

tion Conditions" in the chapter 7 of the

fi-5950 Operator's Guide?

Are the Separator roller or the Pick roll-

ers dirty?

Are the Separator roller or the Pick roll-

ers worn out?

Is there any debris on the document feed

path?

Have you set the Paper Thickness on the

Operator panel?

Are the Feed rollers or the Pinch rollers

dirty?

Have you adjusted the Vertical Magnifi-

cation?

Have you adjusted the offset (the scan-

ning starting position)?

Use the documents that satisfy the "Document

Quality" and the "Multifeed Detection Condi-

tions" in chapter 7 of the fi-5950 Operator's

Guide.

Clean the Separator roller or the Pick rollers.

Refer to the fi-5950 Operator's Guide "4. DAILY

CARE".

Replace the Separator roller or the Pick rollers.

Refer to the fi-5950 Operator's Guide "5.

REPLACEMENT OF CONSUMABLES".

Remove any debris from the document feed path.

Set the Paper Thickness thinner.

Refer to

"1.3 Operator Panel" (page.

Clean the Feed rollers or the Pinch rollers. Refer

to the fi-5950 Operator's Guide "4. DAILY

CARE".

Start up the Software Operation Panel, select

[Device Set] and then click the [Offset] button.

Adjust the vertical magnification. Refer to the fi-

5950 Operator's Guide "8.3 Offset/Scan scale".

Start up the Software Operation Panel, select

[Device Set] and then click the [Offset] button.

Adjust the offset setting. Refer to the fi-5950

Operator's Guide "8.3 Offset/Scan scale".

AP-2

Remedy

2).