Fujitsu Video Scanner Installation Procedures
Finally connect the power cord to the scanner and a wall outlet then turn on the scanner.
For those models without a power switch plug in the power supply to the back of the
scanner. To establish communication between the Scanner and your PC system turn on
the scanner prior to turning on your system. The scanner power and LED/LCD display
will light up. Next after the scanner completes its startup initialization the LED/LCD will
display either ready or the number one. This indicates that the scanner is ready.
Special note: On video scanners the ready light will not come on.
Step E: Configuring the scanner driver.
1. Go to Start, Settings, Control Panel, and double click on KSM (Kofax Source
Manager).
2. Click on Next then click on Create and type in a source name (typically the scanner
model).
3. Click on the drop down menu and select Adrenaline in the Source type and click
O.K. On the next screen Select your model scanner on the list and click O.K. to
finish.
Step F: Scanning with VCDEMO32P.
1. Go to Start, Programs, Kofax VRS or Kofax Image Controls, and select
VCDEMO32P.EXE.
2. Next go to Source, Scanner, and click on the drop down arrow; then select the
source that you created in the KSM. Wait a couple of seconds for the Kofax engine
to load, and then place your documents in the scanner.
3. Now go to Source, Properties and select your scanning parameters (i.e. scan
source - Flatbed or ADF, resolution, paper size).
4. Afterwards go to Source, and click on Process Image for single page scans or
Process Batch for multi-page batch scans.
Congratulations! You have successfully completed and tested your scanner installation.
*If you do not have any unzipping software installed on your system, you can download a free
evaluation copy at www.winzip.com.
Rev051806A
Windows 98SE\ME\2000\XP
Page 3 of 3
페이지 인쇄